GoBearings.com
A comprehensive engineers' reference source for radial ball bearings and thrust ball bearing

 


Dynaroll

     Ball Bearing Preload Methods
           Ball bearing failure
              Ball bearing overview
              Ball bearing bore
              Ball Bearing failure modes
              Ball Bearing Fatigue life
              Ball Bearing Load ratings
              Bearing handling
              Bearing Misalignment
              Ball Bearing Mounting and fitting

              Ball bearing wear


  BEARING PRELOAD METHODS

BEARING PRELOAD ASSEMBLY METHODS

Deadweight: A fixed weight is set against the bearing ring while adhesive cures to retain the bearings. This system is used in many applications, and gives well-controlled torque values as well as maximum stiffness. Disadvantages are cure time and special handling of adhesive in mass-production. Care must be taken to allow for relative thermal expansion effects if different materials are used in mating parts (see Thermal Expansion chart.)
Spring: Spring (typically belleville-type) is used to press inner rings together, or a wavy-washer/spiral spring is used to push outer rings apart. This system is easy to assemble, but has minimum stiffness since the spring can move after assembly so that the stiffness of the assembly is controlled by the spring rate rather than bearing raceway/ball elasticity. Thermal effects from relative expansions of mating parts are minimized. Spring preload is often used in high speed applications.  
Solid clamping: Component parts are machined to precise dimensions to remove axial play when races are clamped together. In theory, this system is easy to assemble, has few components and good stiffness. However, due to the wide range of axial play, it is almost impossible to achieve in practice. Unless components and bearings are matched to a high precision the resulting assembly may be damaged through raceway brinelling or may not have adequate preload. (Note: precision matched bearings are available as Duplex Pairs).







Bearing Overview
|| Materials || Cages and Retainers || Shields and Seals || Bearing Geometry || Abec Tolerance
Lubrication || Load Rating and Lifetime || Bearing Failure || Noise || Torque || Mounting and Fitting
Preload || Bearing Handling || Adhesive Practices || Assembly Characteristics || Specify a Bearing
Ball Bearing News || Site Map

Dynaroll Copyright 2005